污泥基生物炭提升活性污泥系统处理性能

对污泥基生物炭提升活性污泥系统处理性能进行探讨,将活性炭和污泥基生物炭分别投入A²O工艺厌氧池活性污泥,发现其对COD削减率最高分别为72.9%和41.1%,均能有效削减,生物炭对TN削减率最高为74.1%,优于活性炭.表征显示污泥基生物炭上更易附着活性污泥且比表面积更大.在A²O小试厌氧池中以"1次/污泥龄"为频率投加活性炭、污泥基生物炭和脱脂污泥基生物炭,结果发现:投加污泥基生物炭对COD、TN、TP的削减均优于活性炭,投加脱脂污泥基生物炭对COD、TN的削减与投加活性炭相当,对TP平均削减率高达85.6%,优于活性炭,表明生物炭处理(BT)工艺比粉末活性炭处理(PACT)工艺处理生活污水能力更强,脱脂污泥基生物炭作为污泥脂质提取后的副产品更经济.     

污泥掺烧对燃煤电厂痕量元素排放特性影响

采用EPA Method 29方法、冷原子吸收光谱法和电感耦合等离子体质谱法采集和分析一台超低排放燃煤机组污泥掺烧前后的原燃料、烟气和副产物样品中各痕量元素浓度,研究污泥掺烧对燃煤电厂痕量元素排放特性的影响.结果表明：污泥中富含Zn、Cu元素,浓度分别是煤样中的18.81倍和17.64倍.污泥掺烧使掺配后入炉煤中痕量元素含量普遍升高.污泥掺烧前后整个系统、锅炉系统和全流程大气污染控制设施的痕量元素质量平衡率均在可接受范围内.污泥掺烧对痕量元素的分布特征无明显影响,随粉煤灰排放是痕量元素的主要排放去向.通过烟囱排放到大气环境的痕量元素排放量占比很小,不超过0.43%.污泥掺烧前后SCR入口烟气中痕量元素除Hg外主要以颗粒态形式存在.污泥掺烧后各痕量元素在粉煤灰和底渣中的相对富集系数未显著改变.经过全流程大气污染控制设施协同控制后,污泥掺烧前后烟囱总排口痕量元素排放浓度分别为0~12.76,0~14.97μg/m³.污泥掺烧后痕量元素排放浓度均满足美国燃煤发电机组有害大气污染物排放标准、上海市燃煤耦合污泥电厂大气污染排放标准和生态环境部生活垃圾焚烧污染控制标准的限值要求.现有的燃煤电厂大气污染控制系统对6%污泥掺烧比工况下痕量元素排放的控制具有较好的适应性.     

类水滑石对污泥焚烧飞灰浸出液中磷的纯化

采用Mg-Fe型类水滑石（LDH）吸附剂提纯污泥焚烧飞灰（ISSA）浸出液中的磷,探究了吸附剂煅烧对磷吸附效果的影响及磷吸附和脱附机理.研究发现,在高浓度磷溶液（>1000mg/L）中,未煅烧的类水滑石（LDHu）磷吸附容量高于煅烧后的类水滑石（LDHc）.LDHu具有典型的层状结构,磷的吸附与脱附主要通过磷和金属离子沉淀-溶解、静电吸附-排斥、配位作用和离子交换实现.而LDHc层状结构消失,形成双金属氧化物,不存在明显的阴离子交换作用.经LDHu或LDHc吸附和NaOH溶液脱附后,ISSA浸出液均具有良好的磷纯化效果,磷相对纯度从36%分别上升至77%和69%,磷回收率分别为84%和57%.纯化后的溶液适合制备高值含磷产物.     

pH值调控柠檬酸污泥厌氧发酵产酸及碳源潜力研究

以柠檬酸废水厌氧颗粒污泥为接种物,在不同pH值调控条件下开展柠檬酸生产废水剩余活性污泥厌氧发酵产酸研究。通过对发酵液挥发性脂肪酸(VFAs)、有机质、氮磷和污泥脱水性能的分析,探讨了柠檬酸污泥厌氧产酸机制。结果表明,pH³10的碱性条件更有利于有机质的溶出从而促进VFAs的产生。三维荧光光谱分析发现在恒定pH值下腐殖酸(HA)和富里酸(FA)会大量溶出降低VFAs的产量。初始pH=10是柠檬酸污泥厌氧产酸的最佳pH值,发酵4d的VFAs浓度最高达(6681.47±126.82)mg COD/L,是文献报道中市政污泥产酸量的近2倍,其中乙酸占比49.8%,发酵后产酸功能菌Chloroflexi、Bacteroidota的相对丰度分别由初始的9.52%、10.87%增至16.84%、14.39%,污泥归一化毛细吸水时间(n_CST)为(11.34±0.27)s×L/g,脱水性能良好,发酵液TP浓度为(20.45±0.33)mg/L。研究表明,利用柠檬酸剩余活性污泥碱性厌氧发酵产酸作为污水处理过程中的外加碳源具有较大潜力。     

铁盐浸渍强化污泥活性炭-甲醇热质传递特性

针对以市政污泥为核心的炭素前驱体开展原位铁盐浸渍磁修饰,通过响应曲面试验设计优化并制备了新型原位浸渍炭IM-WNC;以成品炭的后浸渍磁修饰炭PM-WNC为参比,考察了原位浸渍与后浸渍磁修饰过程对污泥活性炭-甲醇工质对的吸附/解吸速率、吸附等温线、吸附床传热性能、制冷量及制冷功率等方面的影响。结果表明:与后浸渍过程相比,原位铁盐浸渍有利于保持污泥炭总孔容积(0.6608cm³/g)及比表面积(1122m²/g)水平,能显著提升致密化污泥炭IM-WNC的导热系数(600kg/m³,4.586W/(m·K))、甲醇Sokoda&Suzuki平衡吸附量((528.74±15.86)mg/g)和Langmuir最大吸附量((673.99±13.52)mg/g)。升温脱附与冷却吸附循环体系内,IM-WNC致密化吸附床中心温度峰谷差值可达到69.07℃。当循环时间为76min,解吸温度为100℃时,IM-WNC吸附制冷床的制冷量和制冷功率分别达到501.43kJ/kg和799.06kJ/(kg·h),较PM-WNC分别提升了15.61%和18.69%。     

Enhancing anoxic denitrification of low C/N ratio wastewater with novel ZVI composite carriers

External organic carbon sources are needed to provide electron donors for the denitrification of wastewater with a low COD/NO₃^--N（C/N） ratio, increasing the treatment cost. The economic strategy is to enhance the bioactivity and/or biodiversity of denitrifiers to efficiently utilize organic substances in wastewater. In this study, novel zero-valent iron（ZVI） composite carriers were prepared and implemented in a suspended carrier biofilm reactor to enhance the bioactivity an...     

A novel approach to estimate and control denitrification performance in activated sludge systems with respirogram technology

Respirogram technology has been widely applied for aerobic process, however, the response of respirogram to anoxic denitrification is still unclear. To reveal such response may help to design a new method for the evaluation of the performance of denitrification. The size distribution of flocs measured at different denitrification moments demonstrated a clear expansion of flocs triggered by denitrification, during which higher specific endogenous and quasi-endogenous respiration rates (SOUR_e and SOUR_q) were also observed. Furthermore, SOUR_q increases exponentially with the specific denitrification rate (SDNR), suggesting that there should be a maximum SDNR in conventional activated sludge systems. Based on these findings, an index R_q/t, defined as the ratio of quasi-endogenous (OUR_q) to maximum respiration rate (OUR_t), is proposed to estimate the denitrification capacity that higher R_q/t indicates higher denitrification potential, which can be readily obtained without complex measurement or analysis, and it offers a novel and promising respirogram-based approach for denitrification estimation and control by taking measures to extend anoxic time to maintain its value at a high level within a certain range.     

Potassium ferrate pretreatment promotes short chain fatty acids yield and antibiotics reduction in acidogenic fermentation of sewage sludge

During the acidogenic fermentation converting waste activated sludge (WAS) into short-chain fatty acids (SCFA), hydrolysis of complex organic polymers is a limiting step and the transformation of harmful substances (such as antibiotics) during acidogenic fermentation is unknown. In this study, potassium ferrate (K₂FeO₄) oxidation was used as a pretreatment strategy for WAS acidogenic fermentation to increase the hydrolysis of sludge and destruct the harmful antibiotics. Pretreatment with K₂FeO₄ can effectively increase the SCFA production during acidogenic fermentation and change the distribution of SCFA components. With the dosage of 0.2 g/g TS, the maximum SCFA yield was 4823 mg COD/L, which is 28.3 times that of the control group; acetic acid accounts for more than 90% of the total SCFA. The higher dosage (0.5 g/g TS) can further increase the proportion of acetic acid, but inhibit the overall performance of SCFA production. Apart from the promotion of hydrolysis and acidogenesis, K₂FeO₄ pretreatment can also simultaneously oxidizes and degrades part of the antibiotics in the sludge. When the dosage is 0.5 g/g TS, the degradation efficacy of antibiotics is the most significant, and the contents of ofloxacin, azithromycin, and tetracycline in the sludge are reduced by 69%, 42%, and 50%, respectively. In addition, K₂FeO₄ pretreatment can also promote the release of antibiotics from sludge flocs, which is conducive to the simultaneous degradation of antibiotics in the subsequent biological treatment process.     

污水处理工程--两段式活性污泥工艺

我国中小城市的污水处理通常有如下特点(1 )工业废水所占比重较大,甚至超过50 %,致使要处理的城市污水的污染物浓度较高,污染物负荷变化较大 ;(2)城市财政状况比较紧张,可用于建设污水处理厂的资金有限.两段式活性污泥工艺是对传统活性污泥工艺的改进,在好氧处理之前采用一个缺氧或厌氧段,用于有机物的水解酸化或生物除磷.两段式工艺有以下优点处理效率高、工程投资和日常运行费用低,更适合我国国情.本文以两个工程项目为例,论述了两段式活性污泥工艺的工程设计与实际应用.山东省招远市污水处理厂于1999年7月投入运行,处理后排放水中的污染物指标低于设计值.蓬莱市污水处理厂工程即将竣工,设计处理能力20000m3 /d,工程总投资约1200万元,远远低于目前国内的平均水平.     

活性污泥模型研究及其工艺软件的发展

本文综述了活性污泥模型从基于Monod方程的稳态模型到以ASM1、ASM2、ASM3为代表的动态模型的发展过程 ,介绍了各代表性模型的特点并对当前典型的活性污泥工艺软件作了评述 ,提出其研究方向及发展趋势